1.
Locate connector P3 on
cable assembly 147959-1.
(P3 is the 9 pin "D" connector
with 2 cables connected to it.
2.
Remove the 2 screws hold-
ing P3 together, using the
screw driver.
3.
Open unit as shown to
remove RTV.
4.
Remove adhesive sealant
in the backshell area of con-
nector P3, using alcohol,
Q-Tips, and tweezers.
5.
Using the XACTO knife,
remove the heat shrink tub-
ing at the splice between
P3 pin 8 and P2 pin 3 AND
between P3 pin 9 and P2
pin 4.
6.
Using the soldering iron,
unsolder the splice connection between P3 pin 8 and
P2 pin 3.
AND between P3 pin 9 and P2
pin 4.
7.
Clean both solder con-
nections above with the
alcohol and Q-tips and Prep
solder connections.
8.
Install a short length of
heat shrinkable tubing over
the P3 pin 8 wire and P3 pin
9 wire.
9.
Solder the P2 pin 4 wire to
P3 pin 8 and P2 pin 3 wire to
P3 pin 9.
10.Move
the heat shrinkable
tubing so that it completely
insulated the splices at P3
pin 3 and P3 pin 4.
11.
Using the heat gun,
shrink the shrinkable tubing
at the above splices
completely.
12.Pot
connector P3 back-
shell area, after alteration is
complete, with adhesive
sealant. Re-assemble con-
nector P3, install and tighten
screws removed in step 2.
13.
Using a multimeter,
verify continuity between
P2 pin 4 and P3 pin 8. Also
verify continuity between
P2 pin 3 and P3 pin 9.
